Installation

24V/1A DC is required to power converter. Standard consumption is lower, but switched-mode power supply requires high inrush current.

1. Jumper - RS485 terminator
2. RS 485 [C-bus] connector
3. RS 232/MMI connector
4. Ethernet
5. USB Slave
6. Do not connect
7. Jumper - MMI power supply bridge between RS 232 DB9 and port 3.
8. Power supply 24V DC

1. Shielding
2. A+
3. B-
4. GND

1. GND
2. MMI power
3. TxD
4. RxD

1. -24VDC
2. +24VDC

With reverse polarity protection

1. RS 232 DB9
2. USB Host
3. HDMI Do not connect
4. Micro SD slot
5. M-Bus

1. M-Bus
2. M-Bus

With protection against overvoltage and short circuit
In the event of prolonged short-circuit situation, converter will reduce output voltage. To restore converters function it is required to break converters power supply.

  RS485 - /dev/ttyO5
  M-Bus - /dev/ttyO4
  RS232 DB9 - /dev/ttyO1
  RS232 MMI - /dev/ttyO2

From factory settings, converters IP address is set to 192.168.0.202. You will be able to connect to converter by setting your IP address in range 192.168.0.XXX with net mask set to 255.255.255.0

Converter requires about 1 minute to start all services with web interface. Web inteface should be accessible on web address http://192.168.0.202
Login page will be displayed after successfull connection.
Default credentials are:
Username: root
Password: 123
By pressing Login button you will log in.
It is recommended to immediately change default password, especially when device is visible on public network
Credentials to web interface are identical with credentials used for ssh.

You can change your pasword by clicking on your username located in menu below logo. Small context menu should pop up with option to Change password.

You can also access integrated helper by directly accessing following links, each for different language:
<converters IP>/wiki/sk/blacky_max.html
<converters IP>/wiki/en/blacky_max.html
<converters IP>/wiki/de/blacky_max.html