en:blacky-install
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
en:blacky-install [2017/04/25 08:50] – [Peripherals description] arsi | en:blacky-install [2017/04/26 09:40] – [Peripherals description] arsi | ||
---|---|---|---|
Line 8: | Line 8: | ||
{{ : | {{ : | ||
- Jumper - RS485 terminator | - Jumper - RS485 terminator | ||
- | - RS 485 connector | + | - RS 485 [C-bus] |
- RS 232/MMI connector | - RS 232/MMI connector | ||
- Ethernet | - Ethernet | ||
Line 16: | Line 16: | ||
- Power supply 24V DC | - Power supply 24V DC | ||
- | === RS 485 connector | + | === RS 485 connector === |
- **Shielding** | - **Shielding** | ||
- **A+** | - **A+** | ||
- **B-** | - **B-** | ||
- **GND** | - **GND** | ||
- | === RS 232 connector | + | |
+ | {{ : | ||
+ | === RS 232 connector === | ||
- **GND** | - **GND** | ||
- **MMI power** | - **MMI power** | ||
Line 34: | Line 36: | ||
---- | ---- | ||
{{ : | {{ : | ||
- | - RS 232 DB9 [/ | + | - RS 232 DB9 |
- USB Host | - USB Host | ||
- HDMI **Do not connect** | - HDMI **Do not connect** | ||
Line 40: | Line 42: | ||
- M-Bus | - M-Bus | ||
- | === M-Bus connector | + | === M-Bus connector |
- M-Bus | - M-Bus | ||
- M-Bus | - M-Bus | ||
Line 47: | Line 49: | ||
:!: In the event of prolonged short-circuit situation, converter will reduce output voltage. To restore converters function it is required to break converters power supply. | :!: In the event of prolonged short-circuit situation, converter will reduce output voltage. To restore converters function it is required to break converters power supply. | ||
---- | ---- | ||
+ | === Linux COM port names === | ||
+ | |||
+ | RS485 - /dev/ttyO5 | ||
+ | M-Bus - /dev/ttyO4 | ||
+ | RS232 DB9 - /dev/ttyO1 | ||
+ | RS232 MMI - /dev/ttyO2 | ||
+ | |||
+ | ---- | ||
+ | |||
===== First run ===== | ===== First run ===== | ||
:!: From factory settings, converters IP address is set to **192.168.0.202**. You will be able to connect to converter by setting your IP address in range **192.168.0.XXX** with net mask set to **255.255.255.0** | :!: From factory settings, converters IP address is set to **192.168.0.202**. You will be able to connect to converter by setting your IP address in range **192.168.0.XXX** with net mask set to **255.255.255.0** |
en/blacky-install.txt · Last modified: 2018/02/23 22:29 by 127.0.0.1